Required specimens shall be tested as submitted except that any protective masking or protective material shall be removed prior to the test. Any applied coating integral to the specimens shall not be removed. The specimens shall be conditioned to a uniform test temperature between 65F and 85F The test apparatus shall consist of a test frame and an impactor system. The test frame consists of a main frame mounted on two base beams with stiffening members and a subframe, in which the specimen is held. The impactor system consists of the impactor, traction, release, and suspension devices.
|Published (Last):||16 May 2005|
|PDF File Size:||20.67 Mb|
|ePub File Size:||7.21 Mb|
|Price:||Free* [*Free Regsitration Required]|
ANSI Z The consensus committee that approved the Standard was balanced to ensure that individuals from competent and concerned interests have had an opportunity to participate. It was developed within the approved scope as stated in section 1. This Standard is available for public review on a continuing basis. This provides an opportunity for additional public input from industry, academia, regulatory agencies, and the public-at-large.
The use of an addenda system will allow revisions made in response to public review or committee actions to be published as required. This Standard, which is the result of extended and careful consideration of available knowledge and experience on the subject, is intended to provide minimum requirements that are recommended for use, adoption, enforcement by federal, state and local authorities and by model codes.
This standard is to be referenced but not incorporated in any statute or any other standard without the prior written permission of the publisher. This Standard does not recommend where safety glazing should be used or, when it is used, what type of glazing material should be used. Neither the standards committee nor the secretariat feel that this standard is perfect or in its ultimate form.
It is recognized that, although safety-glazing materials are widely used and accepted, new developments are to be expected and revisions of the standards are necessary as the art progresses and further experience is gained.
This standard is a successor standard to the e2 edition. The e2 standard succeeded those of the e, , , reaffirmed in , , and editions. No test methods, references or exceptions appear in this document for Class C, 12 inch drop height and fire-rated wired glass. Compliance of all safety glazing products must be rated to either Class A or Class B in accordance with the procedures of this edition. In order for material to be considered for reference or to continue to be referenced in the ANSI Z The standard or portions of a standard intended to be enforced shall be written in mandatory language.
The scope or application of the reference material shall be clearly described. The referenced material shall not have the effect of requiring proprietary materials. The standard shall not prescribe a proprietary agency for quality control or testing. For communication with the Committee please refer to the following page General. ANSI Codes and Standards are developed and maintained with the intent to represent the consensus of concerned interests.
As such, users of this Standard may interact with the Committee by requesting interpretations, proposing revisions, and attending Committee meetings. Correspondence should be addressed to: Secretary, Z97 Main Committee.
ANSI Z97.1: Safety Glazing Materials Used in Buildings
ANSI Z97 1-2004 Safety Glazing
- FORMACION Y ORIENTACION LABORAL EDITEX PDF
- GEOSYSTEMS AN INTRODUCTION TO PHYSICAL GEOGRAPHY 3RD CANADIAN EDITION PDF
- FRANTZ FANON BLACK SKIN WHITE MASK PDF
- ANTIFOSFOLIPIDOS Y EMBARAZO PDF
- ALIAZALEA NOVEL PDF
- BALAAN UDAYAR NOVEL PDF
- ALE EDI & IDOC TECHNOLOGIES FOR SAP 2ND EDITION PDF
- EL LEGIONARIO ALEJANDRO ESPINOSA PDF